HOWTO INSTALL BUSBAR OF SMART GLASS PRIVACY FILM
WWW.CNCNEXT.COM WWW.HELLOGLASS.COM Peter Shin
You can DIY the busbar by yourself, following is instruction. If you have doubts, please feel free to contact us. cnc@cncnext.com Cut a piece out of one angle of UP side of smart film.(The length of the cut is about 30% of the smart glass film)
Cut a piece out of one angle of UP side of smart glass film Cut PET out of one angle of DOWN side of smart glass film
Use the ethanol to wash the cuts in both side
Use the ethanol to wash the cuts in both side
Use ethanol to wash the cuts in both side of smart glass film until it is clean
Pepare the conductive glue (if it’s too dense, you can use 99% ethanol to dilute conductive glue)
Draw conductive glue onto the cut on both sides of smart glass film. Make sure the conductive glue not touch the un-cut smart film edges Draw conductive glue onto the cut
Draw conductive glue onto the cut
Draw conductive glue onto the cut. Make sure the conductive glue not touch the UNCUT smart glass film edges
Use dryer to dry the conductive glue
Put the copper tape onto the conductive glue
Put the copper tape onto the conductive glue
Put the copper tape onto the conductive glue
Put the copper tape onto the conductive glue, make sure the copper of one side is longer to be bent on to the other sizde, so we can soldering both electrodes on same side
Put the copper tape onto the conductive glue, make sure the copper of one side is longer to be bent on to the other sizde, so we can soldering both electrodes on same side
Put the copper tape onto the conductive glue, make sure one copper of one side is longer to be bent on to the other sizde, so we can soldering both electrodes on same side
Soldering both electrodes on same side
Use insulating tape to seal the busbar
Use insulating tape to seal the busbar
Connecting with power device and turn on the switch, you will see the smart film is transparent
“Turn off the switch, you will see the smart film is frosted. Now you have finished installing the busbar of smart glass film. Congratulations！
If you have doubts, pleae feel free to contact Peter at this Email address: cnc@cncnext.com”
“SMART GLASS FILM is composed by two transparent conductive film laminating with a polymer liquid core. And the polymer liquid core composes crystal ball and polymer. When the light pass through the SMART GLASS FILM and reach the liquid crystal ball and polymer, the light is scattering. And the SMART GLASS FILM appears translucent. When electricity power is connected, the polymer-liquid crystal core is allowing light pass through, the SMART GLASS FILM appears transparent.”
“All rights reserved by CNC-INTERLAYER TECH:
【1】CNC-Smart® SMART FILM FOR PRIVACY SWITCHABLE GLASS
【2】CNC-Force® EVA INERLAYER FOR ARCHITECTURAL LAMINATED GLASS 【3】CNC-Shield® PVB INTERLAYER FOR AUTOMOTIVE WINDSHIELD GLASS Web: www.CNCnext.com
Mail: cnc@cncnext.com
benext77@gmail.com/
benext77@hotmail.com”
HOWTO INSTALL BUSBAR OF SMART GLASS PRIVACY FILM.pdf